Omega Vehicle Security OMB-NETSCAN 1500 User Manual download pdf (Page 205)

Appendix C Configuration Aspects for Programmers

NetScan User’s Manual C-9

CSN14/HV/S Configuring High Volts Channels

When the CSN14/HV/S signal conditioning module is used, NetScan measures high voltages providing a

programmable range per channel. To configure the channels on a CSN14/HV/S, use the Configure Channel (

)

command to assign a range to each channel on the signal conditioning module. Channels not included in the

channel scan do not have to be configured.

In addition to channel type, each channel in the scan can optionally have a high and low alarm level and

hysteresis associated with it. NetScan’s alarms allow the unit to produce an internal event when the value of a

channel is outside of desired limits. These alarm events can be used as trigger or stop events, or as a stimulus

for TTL-level signals on the NetScan back panel. More information on using alarms appears later in this

appendix, in the section Configuring Alarms.

The CSN14/HV/S supports both DC and AC voltages. Simply select the desired channel type during

configuration.

Type Volts DC Type Volts AC*

20 ± 2.5 V 28 2.5 V

21 ± 25 V 29 25 V

22 ± 250 V 30 250 V

Note:

Above mentioned ranges are maximum peak-to-peak signals for AC volts.

Vrms values are accurate to 70.7% of peak value.

The

type

parameter is what distinguishes the channel as a high volts channel. The channel configuration

cannot be changed while the trigger is armed or an acquisition is taking place.

Note: Additional information can be found under the command reference for

in Appendix A.

Scan Configuration

Configuring a Scan

Although 128 channels are available for scanning when an expansion chassis is added to the NetScan unit, only

those channels configured in the channel scan are collected and available to the controlling computer. Channels

are always scanned in ascending order, regardless of the sequence you input. The same configuration is used in

reading channel data through the High/Low/Last Registers or the Acquisition Buffer.

Scan configuration is also accomplished using the Configure Channels (

) command. This command allows up

to 128 channels to be specified by either assigning individual channels or entering a range of channels. The 128

possible channels can be configured in any sequence, but the scan will be ordered sequentially by NetScan.

Note: Channels cannot be accessed randomly as part of a channel scan.

Configuring the Scan Interval

The scan interval is the frequency at which the scans are acquired. It can be programmed via the Set Scan

Interval (

) command from a 99-hour period down to as fast as the unit can run under the current channel

configuration. The normal scan interval can be programmed in increments of 0.1 seconds.

NetScan has two distinct scan intervals:

•

normal scan interval The normal scan interval is used when NetScan is collecting scans before the start

event has occurred or after stop event has occurred. These two regions are called the pre-trigger scan and

the post-stop scan, respectively.

•

acquisition scan interval The acquisition scan interval is used when the NetScan is acquiring scans after

the start event has occurred but before the stop event has occurred. This region is referred to as the post-

trigger scan.

1 2 ... 200 201 202 203 204 205 206 207 208 209 210 ... 255 256

Omega Vehicle Security OMB-NETSCAN 1500 User Manual Page 205

Comments to this Manuals

Omega Vehicle Security OMB-NETSCAN 1500 User Manual Page 205

Comments to this Manuals

Related products and manuals for Measuring, testing & control Omega Vehicle Security OMB-NETSCAN 1500